Zips panel

Prefabricated panel system below finish floor.

Sandwich panels ZIPS are snap-together panel system for floor insulation below finish floor (parquet, linoleum, carpet, etc.). If the screed to make you and or for You is a time – consuming labor- come to the aid of panels ZIPS.

Composition: the panel consists of staple fiber, gypsum fiber Board sheets 2 layer reference Sylomer isolators (8 on each sheet)and finish sheet of plywood with thickness of 18mm.

With these panels completely solved the problem of sound insulation of interfloor overlapping as impact and airborne noise.

The advantages of these systems:

  • the lack of "wet" processes
  • speed of installation
  • excellent performance at small thickness of the panels
  • the presence of vibropacked provide uniform adhesion of plates to the floor
  • the panels are connected joint to joint
  • the presence of vibromassazhery nodes


ZIPS-FLOOR VECTOR
The fine design team for sound proofing the floor.
Option for clearing small household noise: conversation, give dogs, the sound of the TV, radio. The working range for insulation from airborne noise from 100 Hz.

Dimensions of panels: 1200 x 600 mm (without square crests).
Thickness: 45 mm.
Total thickness 80mm
Thickness with a finishing layer of plywood: 83 mm
The weight of the system: 18.5 kg

Features:

  • The surface density of system precast ZIPS-FLOOR-Vector: 61,5 kg/m2.
  • According to field tests taking into account the indirect paths of sound transmission loss index of impact sound team panel system ZIPS-POL Vector: ΔLn,w = 32 dB.
  • According to field tests taking into account the indirect paths of sound transmission index of the additional airborne sound insulation panel system ZIPS-POL Vector: ΔRw = 6 – 8 dB.

ZIPS-FLOOR MODULE
Option to eliminate household noise at frequencies from 80Hz. The thickness of the system more, but works better at lower frequencies. The indicators to reduce the air noise is much higher!

Dimensions of panels: 1200 x 600 mm (without square crests).
Thickness: 75 mm.
Thickness with a finishing layer of plywood: 110 mm.
The weight of the system: 19 kg.

Features:

  • The surface density of system precast ZIPS-FLOOR Module: 62 kg/m2.
  • Index of reduction of impact sound team panel system ZIPS-FLOOR Module: ΔLn,w = 38 dB.
  • Additional index of airborne sound insulation panel system ZIPS-FLOOR Module: ΔRw = 7 – 9 dB.

The installation process:

  1. Surface preparation – clean off dirt and debris, it is desirable to align.
  2. To glue the perimeter of the wall of Vibrotek-M tape in 2 layers of acoustic sealant Vibrocil on the level above the thickness of the intended thickness of the system.
  3. Laying construction of the film on the rough floor to the school wall to 150mm, with overlapping joints of 100mm. To seal the joints with construction tape.
  4. Installation of sandwich panels, the connection of tongue-and-groove joints additionally with screws. The trim panels.
  5. Laying on top panel, finishing layer of plywood on special mastic.
  6. Trimming damper on the perimeter. Seal all joints with acoustic sealant Vibrocil.

Other products